Error 01: Left wheel error
There is too much load on the left wheel or it cannot turn. Check whether the left wheel is stuck.
Error 02: Right wheel error
There is too much load on the right wheel or it cannot turn. Check whether the right wheel is stuck.
Error 03: Cliff sensor error
The cliff sensor is not functioning properly. Check whether the sensor is dirty or obstructed.
Error 04: Low battery
Vacuum-mop runs at low battery level. Place the vacuum-mop onto the charging dock to recharge.
Error 05: Bumper error
The bumper is not functioning properly and may be jammed. Check to make sure the bumper is not stuck.
Error 06: Brush error
There is too much load on the brush or it cannot turn. Check whether the brush is stuck.
Error 07: Side brush error
There is too much load on the side brush or it cannot turn. Check whether the side brush is stuck.
Error 08: Fan error
The fan cannot rotate or is drawing excessive current. Try restarting the vacuum-mop. If the error persists, please. The fan cannot rotate or is drawing excessive current. Try restarting the vacuum-mop. If the error persists, please contact after-sales service.
Error 09: Dust Compartment/ Water Tank
2-in-1 dust compartment with water tank is not detected. Check whether it is installed correctly.
Error 10: Charging error
Make sure the vacuum-mop is well connected to the charging dock
Error 11: Insufficient water
The water tank has insufficient water. Refill the water tank.
Error 12: Vacuum-mop is of the ground
Move the vacuum-mop to a level surface and start again.
